Electronic components for the hydraulic driveLogo: PEES componentsElektronik-Komponenten für die hydraulische Antribstechnik

Servo Amplifier

AN418

AN418

The AN418 servo amplifier module is intended for the control of proportional valves with two magnets. The snap-on housing enables the AN418 module to be mounted on normal carrier rails in control cabinets. The electrical connections are via a terminal strip and a flat connector (enable input).

The output stage is a duplex output stage with high-dynamic response and rapid deexcitation. These design features ensure rapid switch-off of the magnet coil (approx. 4...6 ms).

Four multi-turn resistors allow the adjustment of volumetric flow amplification (max. A, max. B), and Imin jump (min. A, min. B) to be made separately for each magnet.

Typekey-Description (click to enlarge pictures):

AN 418

Downloads:

Download AN418 (de)    (Size:221 kB)
deutsche Beschreibung
Download AN418 (en)    (Size:214 kB)
english description


 

You are here: Startpage ›› Module

 

Schmuckbild

PEES COMPONENTS
MODULE

The AN 4xx series has been especially developed for those applications where there was a need for compact and easy to install controllers.

As with all PEES Components units, these modules are extremely efficient and of superior quality.

  • easy to maintain, even for non-professionals
  •  extremely fast end stages
  • internal DC/DC conversion, etc.

Click on a link below to get detail information. Also available as PDF-document, you will need the Adobe-Reader to view these documents.

 

AN402 Servo Amplifier

AN404 Servo Amplifier

AN405 Servo Amplifier

AN410 Pressure Controller

AN417 Setpoint Module

AN418 Servo Amplifier

AN419 Servo Amplifier

AN422 Servo Amplifier

AN423 Servo Amplifier

AN424 PID Controller Module

AN430 Servo amplifier/PID Controller