Module
|
Please go to "get Detail information" ! |
AN402 Servo Amplifier
The AN402 servo amplifier module is intended for the control of single magnet proportional valves. The control algorithm, ramps and similar command variables are derived exclusively from an external computer (PLC).
AN404 Servo Amplifier
The AN404 servo amplifier module is intended for the control of proportional valves with two magnets. The snap-on housing enables the AN404 module to be mounted on normal carrier rails in control cabinets. The electrical connections are via a terminal strip and a flat connector (enable input).
AN405 Servo Amplifier
The AN405 servo amplifier module is intended for the control of servo valves. It is available with various current ranges (±20mA, ±100mA, ± 200mA, ±300mA).
AN410 Pressure Controller
The AN410 pressure controller module is intended for pressure closed-loop-controls in conjunction with a pressure control valve. When the controller enable is switched off, the unit operates as an open loop controller in which the system pressure is adjusted in the usual manner by the valve current in conjunction with the control characteristic.
AN417 Setpoint Module
The AN417 setpoint module enables the universal input of setpoints for the control of servo and proportional valves. It has four setpoints and a polarity reverser.
AN418 Servo Amplifier
The AN418 servo amplifier module is intended for the control of proportional valves with two magnets. The snap-on housing enables the AN418 module to be mounted on normal carrier rails in control cabinets. The electrical connections are via a terminal strip and a flat connector (enable input).
AN419 Servo Amplifier
The AN419 servo amplifier module is intended for the control of single magnet roportional valves. The snap-on housing enables the AN419 module to be mounted on normal carrier rails in control cabinets. The electrical connections are via a terminal strip and a flat connector (enable input).
AN422 Servo Amplifier
The AN422 servo amplifier module is intended for the control of proportional valves with two magnets. The snap-on housing enables the AN422 module to be mounted on normal carrier rails in control cabinets. The electrical connections are via a terminal strip and a flat connector (enable input).
AN423 Servo Amplifier
The AN423 servo amplifier module is intended for the control of single magnet proportional valves. The snap-on housing enables the amplifier module to be mounted on normal carrier rails in control cabinets.
AN424 PID Controller Module
This PID controller module has been developed to meet the continuous demand for analog controller units in an easy-to-handle modular form.
AN430 Servo amplifier/PID Controller
The AN430 controller module has been developed, with the controller and servo amplifier accommodated in a single housing, for actuation of servo valves. The servo valve section can be supplied for four different current ranges (±20mA, ±100mA, ±200mA, ± 300mA). Special types for other valve currents are also possible.
You are here: Startpage ›› Module
